Nov 02, 2017 This video describes the BEST way to connect any computer (MAC or PC) to your ATEM switcher as a video source. Many people struggle with getting. Control Panel: Software: ATEM Software Control Panel for both Mac and PC Mac OS x 10.7 Lion or later OS x 10.8 Mountain Lion or later Windows Windows 7 64-bit Windows 8 32/64-bit Note: software included with purchase of ATEM Production Studio 4K: Hardware: ATEM 1 M/E Broadcast Panel ATEM 2 M/E Broadcast Panel Note: hardware panels are. This is accomplished by using either the included software for Mac/PC, or via the ATEM 1 M/E or ATEM 2 M/E Broadcast Panel. Using the Ethernet port on the switcher allows you to connect control surfaces directly to the switcher or you can control the switcher across a network.
I am just setting up a new ATEM Television Studio and I am experiencing issues getting it connected to my computer. I've plugged it into my computer via ethernet, and have actually tried on both a Windows and Mac computer, but am having the same issues on both. On Windows I am getting an unidentifed network, which doesn't seem to be connecting. I've gone into the connection's settings and changed the TCP/IPv4 details to the same IP address & default gateway etc as the chassis settings (having connected to the PC with USB first to get the right settings). It hasn't made any difference and still doesn't connect. I did the same with Mac, having gone into Network settings and enabled 'Ethernet' and manually entered the same IP address, router and default gateway. That then says connected in Network Settings, but when I load the software control utility it also says 'Unconnected'. Any ideas? Many thanks!! JoshEDIT: Solution was to switch 'Allow apps to access your camera' to ON in 'Camera privacy settings' (Windows 10). I can't get OBS and various other programs to properly recognize the ATEM Mini USB 'webcam'. For background: I've read the relevant sections of the manual as far as set-up, connecting to computer, etc, and I've installed the Blackmagic 'ATEM Switchers 8.1 Update' software from 12 Nov 2019. I have two cameras going into the ATEM Mini, both showing fine and switching/cutting properly on the HDMI-connected external monitor. I've tried connecting the ATEM Mini to my computer using two different USB-C to USB-A cables -- one USB 3.1 and one USB 2.0 -- using different 2.0 and 3.0 ports on my computer. The result is the same. Software interactions: I'm able to control the switcher perfectly from the ATEM Software Control program, though whenever I first open the program, I get 'No device connected' displayed for a few seconds before the control panel interface appears. From there I can control the switcher without issue. In OBS, the ATEM Mini is not recognized and doesn't show up as an option when setting up a new Video Capture Device. Atem Control Panel Software Mac Pc DownloadFacebook Live's camera dropdown shows 'Blackmagic Design (1edb:be49)', but when I select it, it says 'Unable to find camera. Please connect a camera and verify correct camera permissions in your browser.' Atem Control Panel Software Mac Pc SoftwareIn Skype camera settings, it doesn't see it at all: 'No device found.'Atem Control Panel Software Mac Pc UpdateNot sure where to go from here, so I'd really appreciate any ideas or suggestions. Thank you!Comments are closed.
|
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |